EV active test lead

The HDT 1935 EV active test lead is THE standard accessory that should be part of every Multifunction Tester (MFT), such as 4 mm test leads or alligator clips. If fits into most standard MFT bags, is super easy to use and supports all relevant measurements of a MFT.

The active test lead is to to simply wire between the EVSE charging point (Type-2 connector) and the measurement inputs of the MFT. All wires of the charging connector are available: L1, L2, L3, N, PE, CP and PP.
This allows to perform typical MFT measurements:

• voltage
• frequency
• phase indication
• phase sequence
• various RCD tests and measurements
• insulation resistance
• low ohm measurements
• line and loop impedances
• etc ....